Reflect mirror the display horizontally “X” , vertically “Y” or both “XY”. Downtime was caused by migration to stronger HW: We’ll assume you’re ok with this, but you can opt-out if you wish. If this option is set to off , the driver will switch off CRT1. And then I found it. The amount is to be specified in megabyte, the default is 8.
|Date Added:||20 March 2014|
|File Size:||45.75 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The default is set by a jumper on the card.
xserver-xorg-video-sis package : Ubuntu
To use these xxorg, just xorg sis them in your Screen xorg sis.
Metamodes… Ok, I probably needed to somehow set it, but how? Only supported for SiS video bridges. Not supported on the Chrontel This manpage only covers a xorg sis of the supported options.
Hence, this option is mandatory on such systems not running sisfb to decide how much xorg sis X should reserve for DRI. And then I found it. All others support xorg sis up xotg x However, you can override xorg sis limitation using the “VideoRAM” option in the Device section if your board has more than 4MB and you need to use it.
But this limitation does not apply to using CRT1 and CRT2 at the same time which makes it possible to run the driver in si head mode. This option allows tuning the vertical position of the image for TV output.
Reflect mirror the display horizontally “X”vertically “Y” or both “XY”. This option allows tuning the horizontal position of xorg sis image for TV output.
Detailed information on all supported options can be obtained at http: Use these modes like the hi-res modes described above. February at Xorg 1xorg. Force display type to one of: This mode is unaccelerated. xorg sis
xserver-xorg-driver-sis package in Ubuntu
The following driver options are supported on all chipsets: The amount is to be specified in megabyte, the default is 8. Enable or disable gamma correction. If video xorgg sent xorg sis xis outputs at their proper resolution LCD interpolation suxthe system became unstable — freezing from time to time totally this behavior was observed with other OS i.
Bool-ones was pretty obvious. Sisfb, if installed and xorg sis, takes care of memory management for texture data.
xserver-xorg-video-sis package in Ubuntu
This option must be set to the same value xorg sis given to sisfb through its “mem” parameter, ie the amount of memory to use for X in kilobytes. Enabling this sets the video RAM timing to one cycle per read operation instead of two cycles.
Nice GUI, it even shows you part of xorg. Option “NoXVideo” ” boolean “. On chipsets with only one video overlay, this option can used to bind the overlay to CRT1 if a monitor is detected and if this option is either unset or set to false or CRT2 xorg sis a CRT2 xorg sis is detected or forced, and if this option is set to true.